Inventor 2016 problem z gwintami

Na tym forum dyskusyjnym rozmawiamy o wszystkim co jest związane z programem Autodesk Inventor.

Moderator: Maciej Śliwiński

ODPOWIEDZ
Aleksx
Posty: 3
Rejestracja: 09 lip 2013, 19:48

Inventor 2016 problem z gwintami

Post autor: Aleksx »

Witam.

Mam problem z tworzeniem gwintów.
Przy próbie tworzenia pojawiają się za pierwszym razem dwa kolejne okna Error z komunikatami
NULLDispatch passed to AutoWrap() i CLSIDFromProgID() failed
i brak reakcji.

Gwintu razem z otworem też nie można stworzyć.


w 2015 jest wszystko OK.
franz80
Posty: 1
Rejestracja: 10 lis 2015, 08:56

Re: Inventor 2016 problem z gwintami

Post autor: franz80 »

Winą jest brak zainstalowanego pełnego pakietu Office a właściwie brak programu Microsoft Excel.

Rozwiązanie można znaleźć na forum producenta - AutoDesk.

Zacytuję:

"Inventor 2015 and earlier versions used an MS component named ADO for reading thread-related spreadsheets. This was changed in Inventor 2016. Now Inventor uses an Excel COM API call instead. Excel Starters and other low-end versions of Excel do not provide an API. Also Open Office or Office 365 are not supported as replacements for a full, locally installed Excel.
Solution:
As a temporary workaround, you can create the following Environmental variable:

Go to Control Panel > System> Advanced System Settings> System Properties, Advanced Tab.
Create a new Environmental variable called "UseLibXL" with a variable value of 1
Retry your clearance/threaded hole creation in Inventor.

This will attempt to use the 3rd party component in Windows instead of Excel. It doesn't support all aspects of what Excel provides but it should work for holes."

W wolnym tłumaczeniu bez programu Excel nie będzie możliwe korzystanie z kilku funkcji, ale możliwość tworzenia gwintów można uzyskac poprzez wprowadzenie nowej zmiennej środowiskowej UseLibXL w windowsie.
ODPOWIEDZ